Features, Utilities and Options

17.Turn the computer on and make sure the added memory is recognized - to confirmed it, Start -> Control Panel -> System and Maintenance -> System icon.

Removing a memory module (Slot A)

To remove the memory module, follow the steps as detailed below:

1.Set the computer to Boot Mode and turn its power off - make sure the Power indicator is off (refer to the Turning off the power section in Chapter 1, Getting Started, if required).

2.Remove the AC adaptor and all cables and peripherals connected to the computer.

3.Turn the computer upside down and remove the battery pack (refer to Replacing the battery pack section in Chapter 6, Power and Power-Up Modes, if required).

Always make sure the display panel is closed in Laptop mode before turning the computer upside down.

4.Follow steps 4 through 9 in Installing a memory module (Slot A) to appear the memory module.

5.Push the latches to the outside to release the memory module. A spring will force one end of the memory module up.

6.Grasp the sides of the module and pull it out.

■If you use the computer for a long time, the memory modules and the circuits locating close to the memory modules will become hot. In this case, let them cool to room temperature before you replace them. Or you will get burnt if you touch any of them.

■Do not touch the connectors on the memory module or on the computer. Debris on the connectors may cause memory access problems.

Latches

Figure 3-9 Removing the memory module

User’s Manual

3-19