Toshiba R400 Supervisor Password, Starting the computer by password, C:\Program Files\Toshiba\PasswordUtility\TOSPU.exe

Power and Power-Up Modes

Supervisor Password

If you set a Supervisor Password, some functions might be restricted when a user logs on with the User Password. To set a Supervisor Password, execute the file TOSPU.EXE. The file is located at:

C:\Program Files\Toshiba\PasswordUtility\TOSPU.exe

This utility lets you do the following:

■Register, delete or change the Supervisor Password.

■Specify restrictions for general users.

Starting the computer by password

If you have already registered a password, there are three ways to start the computer:

■Swipe your fingerprint on the sensor if you have already registered the fingerprint with the Fingerprint utility and enabled Fingerprint System Boot Authentication. If you would not like to swipe your finger or cannot authenticate the fingerprint for some reasons, push the BkSp key to skip the fingerprint authentication screen. You can try to swipe the fingerprint up to five times. If you failed fingerprint authentication five times, you must enter the password manually to start the computer.

■Log on with the Tablet PC Pen when in Tablet mode. Refer to Tablet mode section in this chapter.

■Enter the password manually.

The password is only necessary if the computer was shutdown in Boot Mode or Hibernation Mode.

To enter a password manually, follow these steps:

1. Turn on the power. The following message will appear in the screen:

S Password=

2.Enter the Password.

3.Press Enter.

If you enter the password incorrectly three times in a row, the computer shuts off. In this case, you must turn the computer back on to retry password entry.

6-16 User’s Manual