3 SELECTION OF INSTALLATION
Knockout of Pipe Cover
Rear direction
Pipe cover
Side direction
Front direction
Down direction
Knockout procedure
•The indoor/outdoor connecting pipes can be con- nected to 4 directions.
Take off the knockout part of the pipe cover in which pipes or wires pass through the base plate.
•As shown in the figure, do not remove the pipe cover from the cabinet so that the knockout hole can be easily punched. To knock out, it is easily taken off by hands by punching a position at the lower side of 3 connected parts with screwdriver along the guideline.
•After marking the knockout hole, remove the burr and mount the attached protective bush and guard material for
After connecting the pipes, be sure to mount the pipe cover. The pipe cover is easily mounted by cutting off the slit at the lower part of the pipe cover.
How to remove the front panel
1.Remove screws of the front panel.
2.Pull the front panel downward.
Removing the front panel, the electric parts appear at the front side.
•The metal pipes are attachable to the piping holes. If the size of the used power pipe does not match with the hole, adjust the hole size to match with pipe size.
•Be sure to fix the power cable and indoor/outdoor connecting cable with bundling band sold on the market so that they do not make contact with the compressor and discharge pipe.
(Temperature of the compressor and discharge pipe becomes high.)
In order to avoid the force applied to on the connect- ing section, be sure to fix the cables to the cord clamps provided on the pipe valve fixing plate and the electric parts box.
Electric parts box
Front panel
Pipe valve
fixing plate
Piping 
hole
Cord clamp
42
