Toshiba RD-XS30B owner manual Is your recorder ready?, Turning the power on, Loading a disc

Models: RD-XS30B

1 60
Download 60 pages 43.48 Kb
Page 18
Image 18

Introduction

Before operating this recorder

Is your recorder ready?

Refer to the supplied “INSTALLATION GUIDE” manual and finish the necessary preparations.

Turning the power on

(This owner’s manual instructions are based on the assumption that all proper connections have been completed and the TV is turned on.)

Press the ON/STANDBY button on the front panel of the recorder or the power button on the remote control.

ON/STANDBY indicator

ON/STANDBY button

ON/STANDBY button

CHANNEL button

When the power is turned on, the ON/STANDBY indicator changes from red (standby mode) to green (operation).

After a few seconds, a start-up screen appears. The following icon appears at the top right corner of the screen.

e.g.

Loading

When this icon disappears, the recorder is ready to operate. If the DVD-RAM drive contains a disc, it takes a little longer to start up.

Viewing TV channels through this recorder

After turning the power on, the recorder will output TV channel signals to the connected TV (also in the stop mode).

You can select a desired channel by pressing the CHANNEL buttons.

Loading a disc

Check disc compatibility beforehand ( page 6) and use a proper playable disc.

Caution

Keep your fingers well clear of the disc tray. Neglecting this may causes serious personal injury. Keep a close watch on children.

Do not use a cracked, deformed, or repaired disc.

1Open the disc tray.

Press the button on the front panel or the OPEN/CLOSE button on the remote control.

button

OPEN/CLOSE button

2Insert a disc.

Disc without a cartridge

Insert with the playback side down.

Disc size varies depending on the disc. Place a disc to fit the guide. If a disc is out of the guide, it may result in damage to the disc or malfunction.

Place a disc in the inside hollow.

18

Page 18
Image 18
Toshiba RD-XS30B Is your recorder ready?, Turning the power on, ON/STANDBY indicator ON/STANDBY button Channel button