Connections
Content of the output for each output jack is shown in the following table and differ depending on the
Content of output for each output jack | ||||
"Video Out" | HDMI Output | HDMI | Video | Component |
Setting | Setting * | Output | Output | Output |
Component | Invalid | - | Composite | 480i |
(Interlaced) |
|
|
|
|
Invalid | - | Composite | 480p | |
(Progressive) |
|
|
|
|
| 480p | 480p | Composite | 480p |
HDMI | 720p | 720p | Composite | 480p |
| 1080i | 1080i | Composite | 480p |
| 1080p | 1080p | Composite | 480p |
Note: Both Composite (Video) and Component do not have output when HD JPEG Mode is on 32 , except 480p video resolution mode. You may view photos (JPEG ) through HDMI connection. To watch disc playback through Composite and Component output, set HD JPEG Mode to “Off”.
*Settings for HDMI output format are performed using the HDMI button on the remote control or HDMI SELECT button on the front panel.
Notes
•If Auto is selected, it follows preference HDMI aspect ratio of TV.
•Refer to the owner’s manual of the connected TV as well.
•When you connect the DVD player to your TV, be sure to turn off the power and unplug both units from the wall outlet before making any connections.
•If you have a HDMI (with HDCP) equipped monitor or display, you can connect it to this player using a HDMI cable.
•The HDMI connector outputs uncompressed digital video, as well as almost every kind of digital audio that the player is compatible with, including
•This unit has been designed to be compliant with HDMI (High Definition Multimedia Interface) depending on the component you have connected. Using a HDMI connection may result in unreliable signal transfers.
•Because HDMI is an evolving technology, it is possible that some devices with an HDMI input may not operate properly with this DVD player.
•When using HDMI cable, do not connect to other analog video outputs.
•No sound will be output from the HDMI cable if the digital out is not set to PCM.
•HDMI output is only available when the Video Output is set to “HDMI”. Otherwise the HDMI button is invalid.
Connecting to Optional Equipment
You can enjoy high quality dynamic sounds by connecting the DVD player to optional audio equipment.
Connections
•For connection to your TV, see “Connecting to a TV” .
•This section uses the following reference marks.
: Front speaker
: Rear speaker
: Sub woofer
: Center speaker
: Signal flow
Warning
•When you are connecting (via the COAXIAL DIGITAL AUDIO OUT jack) an AV decoder that does not have Dolby Digital, Digital Theater Systems (DTS) or MPEG2 decoding function, be sure to set “Digital Output” to “PCM” from the
•When playing
Notes
•Do NOT connect the COAXIAL DIGITAL AUDIO OUT jack of the DVD player to the
•Connect the COAXIAL DIGITAL AUDIO OUT jack of the DVD player to the “DIGITAL (COAXIAL)” input of a Receiver or Processor.
•Refer to the owner’s manual of the connected equipment as well.
•When you connect the DVD player to other equipment, be sure to turn off the power and unplug all of the equipment from the wall outlet before making any connections.
•The output sound of the DVD player has a wide dynamic range. Be sure to adjust the receiver’s volume to a moderate listening level. Otherwise, the speakers may be damaged by a sudden high volume sound.
•Turn off the amplifier before you connect or disconnect the DVD player’s power cord. If you leave the amplifier power on, the speakers may be damaged.
13
