11. PROGRAMMING PROCEDURES
11.15 LON SYSTEM
■ Data Transmission |
|
The following data is |
|
Page 1: (0). All (PLU+ING+NUTRI) | Page 2: (0). SPEED KEY |
(1). PLU | (1). LOGO |
(2). ING. | (2). VENDOR |
(3). NUTRITION | (3). FREE FORMAT |
(4). U. PRICE | (4). ADDRESS |
(5). DATE/TIME | (5). INITIAL (#0 - #19, |
(6). MESSAGE LINK (Message) | (9). CHANGE PAGE |
(7). LOCK SCALE (Check the LON cable)
(8). OPEN SCALE (Release the lock after checking the LON cable.)
(9). CHANGE PAGE
n | Enter a DLL data. | ENTER |
p
Release the scale from the error.
0:CANCEL
1:RETRY
2:CONTINUE
NOTE: DLL is performed automatically in the following two ways. It is selectable by the Initial Settings
(1)LOCK SCALE method
Step 1: “LOCK SCALE” is sent. (*1)
Step 2: Selected data is sent. | (*2) | ||
Step 3: “OPEN SCALE” is sent. |
| ||
*1: If an error occurs during step 1, the error terminal ID# is indicated. | |||
Select “cancel”, “retry” or “continue” to release the terminal from an | |||
error. |
|
|
|
cancel: | Quits the operation after sending “OPEN SCALE” | ||
retry: | Tries to send “LOCK SCALE” again. | ||
continue: Ignores the error terminal and starts DLL. | |||
*2: If an error occurs during step 2, the error terminal ID# is indicated. | |||
Press the | CLEAR |
| key to return to the DLL data selection menu. |
(2) Background DLL |
|
|
|
Step 1: Selected data is sent. | (*3) | ||
*3: If an error occurs, the error terminal ID# is indicated. Press the CLEAR key to return to the DLL data selection menu.
