14. OPERATING PROCEDURES
14.2 FIX PRICE OPERATION (FOR US TYPE ONLY)
14.1 WEIGHING OPERATION
Menu: REG., M.DOWN, or REWRAP
Mode: WEIGH
The weigh mode is used to weigh a commodity and to issue the label. The label contains data such as a weight, unit price (price per weight) and total price (calculated as a result of the weighing operation). The following is a basic operation seen at the sales floor of a store or at a back room where different kinds and weights of commodities are repacked. Pressing the [VOID] key subtracts the last entry from the memory.
Example) When PLU #100 and an unit price of $8.00 are set in the speed key #12.
|
|
|
|
|
|
Enter the PLU #. | 1 | 0 | 0 |
| |
|
|
|
|
|
|
Press : PLU
LB |
kg |
Press the | 12 | |
speed key. | ||
|
The unit of measure can be changed for CA model only.
LB ↔ kg
Available only when the initial setting #
lb scale
kg scale
100 g | 1/4 | 1/2 |
|
Place a commodity on the platter.
(Ex. 1.000 lb.)
MANUAL : | : | AUTO |
| * |
|
The label is issued
Press when canceling | VOID |
the last sales. |
<REG.> MANU. WEIGH
| lb | UNIT/$ | TOTAL $ |
| 1.000 | 8.00 | 8.00 |
TEC STORE
(TEL)
(Sample label)
NOTES:
1. Pressing a speed key to which no PLU data has been assigned will result in an error.
| In this case, press the | C | key, then press a speed key to which PLU data has been assigned. | |||||||
2. | To change between AUTO and MANUAL, follow the procedure provided in section 14.9. | |||||||||
3. | If a unit price exceeding 4 digits is obtained by multiplying by 2 or 4 (when pressing the | 1/2 lb | key or | |||||||
| 1/4 lb | key), the unit price will be 0. |
|
| ||||||
|
| |||||||||
|
|
|
| |||||||
4. | 100 g | key is available only when the scale is a kg scale or operated on kg base. | ||||||||
|
|
|
|
|
|
|
| key is pressed, the unit price does change on the display. | ||
5. | When the | 1/2 lb | , | 1/4 lb | or | 100 g | ||||
6.When the “compulsory tare” is selected, a tare must be subtracted in a weighing operation, otherwise an error message “TARE REQUIRED” will be displayed when the following operation has been done:
① Manual mode: Pressing the PRT/* key.
②Auto mode: Placing a commodity on the platter.
③ Floating vendor mode: Pressing the Vendor key.
When a “TARE REQUIRED” is displayed, refer to Section 14.6 to follow the proper weighing procedure.
14- 2
