Optional Devices

Be sure to install memory module to Slot A. The computer does not boot when Slot A is vacant.

Use a 0-bit, Phillips screwdriver to remove and fasten screws. Use of an incorrect screwdriver can damage the screw heads.

Installing memory module (Main memory)

To install a memory module, make sure the computer is in boot mode then:

1.Turn the computer off in boot mode. Refer to the Turning off the power section in Chapter 3, Getting Started.

2.Remove all cables connected to the computer.

3.Turn the computer upside down and remove the battery pack (refer to Chapter 6, Power and Power-Up Modes.)

4.Remove the screw that becomes visible when the battery pack is removed and turn the computer right side up.

Removing the screw

5.Slide the display latch on the front of the computer to the right and open the display panel.

6.Insert a thin object under the rim of the keyboard brace and lift out the brace.

Remove a keyboard brace after surely performing step 4. If step 4 is not performed, there is a possibility of damaging a keyboard brace.

7. Remove two screws securing the keyboard.

TECRA M2

8-7