Toshiba tecra m2 heard, Beep sounds, Sound system, Memory expansion, No sound is heard, Annoying sound is, 5.Turn on the power, 2.Remove the battery

Troubleshooting

Memory expansion

Refer also to Chapter 8, Optional Devices, for information on installing memory modules.

Problem

Beep sounds.

(Two beeps, a dash and a dot, for a defective memory module in slot A.

Three beeps, a dash and two dots for slot B.

When both beeps sound, both memories in slot A and B are defective.)

Procedure

Make sure the memory module installed in the expansion slot is compatible with the computer.

If an incompatible module has been installed, follow the steps below.1.Disconnect the AC adaptor and all peripheral devices.2.Remove the battery.3.Remove the memory module.4.Replace the battery and/or connect the AC adaptor.5.Turn on the power.

If problems persist, contact your dealer.

Sound systemRefer also to documentation for your audio devices.

Problem	Procedure
No sound is heard	Adjust the volume control dial.
	Check the software volume settings.
	Make sure the headphone connection is secure.
	If problems persist, contact your dealer.
Annoying sound is	You may be experiencing feedback. Refer to
heard	Sound system in Chapter 4, Operating Basics.
	If problems persist, contact your dealer.

TECRA M2 9-17