Toshiba tecra m2 not, needs, disk drive, Optical media, Operating Basics, RW, DVD+R, DVD+RW, Floppy disk drive, Some programs run, You cannot access the

Troubleshooting

Check the type of CD/DVD you are using. The drive supports:DVD-ROM: DVD-ROM, DVD-Video, DVD-R,DVD-RW, DVD+R, DVD+RW

CD-ROM: CD-DA, CD-Text, Photo CD (single/ multi-session), CD-ROM Mode 1, Mode 2, CD-ROM XA Mode 2 (Form1, Form2), Enhanced CD (CD-EXTRA), CD-G (Audio CD only), Addressing Method 2

Check the region code on the DVD. It must match that on the DVD±R/±RW drive. Region codes are listed in the Optical media section in Chapter 2, The Grand Tour.

Cannot write correctly If you have trouble writing, make sure you are observing the following precautions:

■Use only media recommended by TOSHIBA.■Do not use the mouse or keyboard duringwriting.■Use only the software supplied with the computer for recording.■Do not run or start other software during writing.■Do not jar the computer during writing.

■Do not connect/ disconnect external devices or install/remove internal cards during writing.

If problems persist, contact your dealer.

Floppy disk drive

For more information, refer to Chapter 4, Operating Basics.

Problem	Procedure
Drive does not operate	There may be a faulty cable connection. Check
	the connection to the computer and to the drive.
Some programs run	The software or hardware configuration may be
correctly but others do	causing a problem. Make sure the
not	hardwareconfiguration matches your software
	needs.
You cannot access the	Try another diskette. If you can access the
external 3 1/2" floppy	diskette, the original diskette (not the drive) is
disk drive	probably causing the problem.
	If problems persist, contact your dealer.

TECRA M2 9-13