Toshiba TLP-T72 owner manual Using the menus, Connecting a computer, How to use the menus

Operating a computer using the remote control

A computer can be operated using the projector’s remote control. This function is available on any computer with the Windows 98/98SE, Windows Me, Windows 2000, or Windows XP OS, that is equipped with a USB port which can support USB1.1 (The mouse remote control receiver is also supported on OS 9 or OS X for the Macintosh). However, please note that Toshiba does not guarantee the operation of all computers.

1Connecting a computer

Connect the projector to a computer using the supplied USB cable. See Fig. (1) below. For models equipped with PC card slot, connect the supplied Mouse remote control receiver to the computer. See Fig. (2) below.

Using the menus

You can call up on-screen menus, and conduct a number of adjustments and settings, using the operation buttons p.16 on the control panel (main unit side) and remote control.

■How to use the menus

The menu shown below is only for operation instructions and might be different from the actual display.

1.Start Display the Setting display menu

2. Select a Category

(1)
		To USB port
USB	1	COMPUTER	2
MONITOR
CONTROL		( Y,PB/PR )

(2)

To USB port

Mouse remote control receiver

2Operating a computer

The mouse remote control function is available when the remote control is set to [PC

Mode]. (See “Switching operation modes” p.20 .)

Point the remote control at the infrared remote sensor (in models using Mouse remote control receivers, point it at the Mouse remote control receiver), and operate the remote control’s buttons.

●Moving the mouse pointer

Move the pointer control button in the direction that you wish the mouse pointer to move, then press.

●To left click

Press the L-CLICK button.

●To right click

Press the R-CLICK button.

●To drag and drop

Move the pointer control button in a (L-)clicked state, then when the pointer is over the desired location, release the button.

●Using the computer’s up and down arrow key functions Press the and buttons to switch PowerPoint® slides.

Remote Control Front Remote Control Rear

Pointer control

L-CLICK

VOL.-	VOL.+
PJ MODE	LASER
	MENU / ENTER
	R-CLICK
	INPUT

R-CLICK

Select a category by using .

There are following four categorys.

Image adjustment menu p.54

Default setting menu	p.54
Display setting menu	p.55
PC card setting menu	p.55

3. Adjustments & Settings

Pressto open the menu of the selected category.

Displays the current adjustments of selected category.

Item shown with gray cannot be adjusted for the current input source.

5. To Finish

Item Adjustment/Setting Value

Finish via the Status display menu.

These marks signify the items can be adjusted/set

by using .

These marks signify an item can be switched by

using .

This mark signfy that there are options.

Press to display a list of options.

To Status display

p.32

The figure shows a typical example. As the display may differ depending on the item, use the following pages as a reference.

These marks signify the items can be selected from

the list by using .

After an item selected, apply it by pressing .

6. End

4. Back

Note

The menu disappears

•Menu adjustments and settings (except Lamp power p.54 ) are saved when the power is turned off via the ON/STANDBY button. If the power cord is unplugged before this, or the power goes out, then the data will not be saved.

Operations

52 53