A500/A500D series

Removing a memory moduleTo remove the memory module, follow the steps as detailed below:

1.Set the computer to Boot Mode and turn its power off - make sure the Power indicator is off (refer to the Turning off the power section in Chapter 3, Getting Started if required).

2.Remove the AC adaptor and all cables and peripherals connected to the computer.

3.Turn the computer upside down and remove the battery pack (refer to Replacing the battery pack section in Chapter 6, Power and Power-up Modes, if required).

4.Push the latches away from the module in order to release it.5.Grasp the memory module by its edges and remove it from the computer.

If you use the computer for a long time, the memory modules and the circuits locating close to the memory modules will become hot. In this case, let them cool to room temperature before you replace them.

Or you will get burnt if you touch any of them.

Do not touch the connectors on the memory module or on the computer. Debris on the connectors may cause memory access problems.

6.Seat the memory module cover in place and secure it with one screw.

Take care to ensure that the memory module cover is firmly closed.

7.Install the battery pack - refer to Replacing the battery pack section in Chapter 6, Power and Power-up Modes, if required.

8.Turn your computer over.

Battery Packs

You can increase the portability of the computer with additional battery packs so that, if you’re away from an AC power source and your battery runs low, you can replace it with a freshly-charged battery. Please refer to Chapter 6, Power and Power-up Modes for further information.

Universal AC Adaptor

If you frequently use your computer at more than one site, it may be convenient to purchase an additional AC adaptor to be kept at each site in order to remove the need to always carry the adaptor with you.

Battery Charger

The battery charger provides a convenient way to charge up to two Lithium Ion battery packs without requiring the use of your computer.

User’s Manual

8-9