Toyota EPS9000 COLOR CHANGE SETTING

OPERATION

PROCEDURE

《

《《

《COLOR CHANGE SETTING》

》》

》

COLOR CHANGE MODE

Sets the color change mode - automatic or manual.

1 Change the display to COLOR CHANGE.

2 Select the desired mode.

3 Press [SET] to confirm the selection.

When the manual mode is set, the

presently used needle number is

displayed as shown below.

4 End of operation

To change the needle bar, refer to

the manual operation step

explained in Page 59.

FD07

***** EMB START ****

AISIN123.10O 1

0/ 1027

01/15: 23456789AB<D>

Press .

*** COLOR CHANGE ***

MODE AUTO

01/15: 23456789ABCDE

Press .

Manual

Automatic

AUTO:Lamp OFF MANUAL:Lamp ON

color change color change

*** COLOR CHANGE ***

MODE MANUAL

01/15: NO.D

Press .

01/15: NO.D

***** EMB START ****

AISIN123.10O 1

0/ 1027

01/15: NO.D

Contents

Main TOYOTA COMPUTERIZED EMBROIDERY SYSTEM INSTRUCTION MANUAL Page CONTENTS PREPARATION OPERATION PROCEDURE OPERATION BASICS FUNCTION MENU ! ! ! DANGER WARNING ! Page SAFETY ! SAFETY ATTEN TIO N ! FD07 PRECAUTIONS Positions and Contents of the Warning Labels DANGER PART NAMES CHECKING THE PARTS ACCESSORIES Page EMBROIDERY MACHINE OPERATION PANEL BOX DIP SWITCHES DIP switch ON or OFF is set as follows: ON * Access to the Embroidery Information 1 2 3 4 5 6 7 8 ON PREPARATION ASSEMBLING CARRYING INSTALLATION WIRING WARNING CONNECTING THE FDD (FLOPPY DISK DRIVE) (TO BE PURCHASED SEPARATELY) SETTING THE UPPER THREAD Upper Thread Setting Procedure TOYOTA SETTING THE UNDER THREAD SETTING THE FABRIC ON THE HOOP SETTING THE HOOP TO THE EMBROIDERY MACHINE Page WINDING THE UNDER THREAD CHECKUPS BEFORE STARTING OPERATION CHECKING THE EMBROIDERY HEAD Check of the Color Change Device and Set Screw Check of Needle Lowered Position OPERATION PROCEDURE OPERATION BASICS STARTING AND STOPPING THE MACHINE Power Switch EMERGENCY STOP Switch STEPS TO START EMBRODIERY Page SCREENS Page Page Page Page Page FUNCTION MENU CHANGING DISPLAY THREAD BREAK SENSOR BOBBIN COUNTER (SET) BOBBIN COUNTER (COUNTER) LOCK STITCH SATIN ADJUSTMENT SLOW START TRIMMING IN JUMP JUMP LENGTH TRIMMING LENGTH TRIMMING TIMING COMMUNICATION SPEED HOOP MENU HOOP MODE INITIALIZATION START POINT RETURN MODE MANUAL SPEED HOOP TIMING OFFSET EDIT DESIGN ROTATION MIRROR DESIGN REPEAT Page COLOR CHANGE SETTING COLOR CHANGE MODE NEEDLE BAR SETTING (INPUT) + + 1 1 0 NEEDLE BAR SETTING (CHANGE) + 1 1 0 PAUSE SETTING DATA SET MENU DATA INPUT (FLOPPY DISK) + DATA INPUT (PC) Page DATA SELECT DATA DELETION MEMORY MODE MEMORY INITIALIZATION MANUAL OPERATION COLOR CHANGE START POINT RETURN MODE TRACE OFFSET (POSITION SETTING) OFFSET (HOOP TRAVELING) TRIMMING HOOP FORWARD/BACK (TRAVEL UNITS) HOOP FORWARD/BACK (n-STITCH FEED) HOOP FORWARD HOOP BACK OUTLINE OF FUNCTIONS ROTATION MIRROR REPEAT OFFSET 1. Manual Offset 2. Automatic Offset SATIN ADJUSTMENT TRACE TROUBLESHOOTING AND MAINTENANCE DAILY MAINTENANCE Maintenance Stop WARNING Cleaning Lubrication Greasing PROGRAM INSTALLATION [When installing from personal computer] Page Page [When installation from FDD] Page IF MACHINE OPERATION IS INTERRUPTED 1 2 3 4 5 6 7 8 10 11 12 13 14 IF MACHINE STOPS DUE TO OCCURRENCE OF A TROUBLE SPECIFICATION