OPERATION
PROCEDURE
69
MEMORY INITIALIZATION
Clears all memory-stored design data.
1 Change the display to DATA MENU.
2 Change the displayed items.
3 Select "5. INITIAL MEMORY".
4 Press [SET] to initialize the memory.
5 Press [SET] to confirm the operation.
The message below is displayed
during memory initialization.
6 End of operation
Since all design data has been
deleted, input the design data at
this step.
To restore the EMB START screen
without inputting the design data,
press the ESC key. The EMB
START screen will be as shown
below if there is no data set as the
embroidery data.
FD07
***** EMB START ****
AISIN123.10O 1
0/ 1027
01/15: 23-456789A<D>
1
Press .
***** DATA MENU ****
1INPUT DATA PC
2.SELECT DATA
3.DELETE DATA
.Press .
***** DATA MENU ****
4 MEMORY MODE
5.INITIAL MEMORY
.Move the cursor using (hoop
travel key).
***** DATA MENU ****
4.MEMORY MODE
5 INITIAL MEMORY
.Press .
** INITIAL MEMORY **
DELETE ALL DATA OK ?
[Y=SET,N=ESC]
Press . *** INITIALIZING ***
***** DATA MENU ****
1INPUT DATA PC
2.SELECT DATA
3.DELETE DATA
.
***** EMB START ****
. 1
0/ 0
01/00: (D)