TP-Link TL-WA5210G manual Dhcp Clients List, Address Reservation

provides two DNS servers. The factory default setting is 0.0.0.0.

Click Save to save the changes.

)Note:

To use the DHCP server function of the device, you should configure all computers in the LAN as "Obtain an IP Address automatically" mode. This function will not take effect until the device reboots.

4.7.2DHCP Clients List

Selecting DHCP > DHCP Clients List will enable you to view the Client Name, MAC Address, Assigned IP and Lease Time for each DHCP Client attached to the device (Figure 4-23).

Figure 4-23 DHCP Clients List

¾ID - Here displays the index of the DHCP client.

¾Client Name - Here displays the name of the DHCP client.

¾MAC Address - Here displays the MAC address of the DHCP client.

¾Assigned IP - Here displays the IP address that the AP has allocated to the DHCP client.

¾Lease Time - Here displays the time of the DHCP client leased. Before the time is up, DHCP client will request to renew the lease automatically.

You cannot change any of the values on this page. To update this page and to show the current attached devices, click on the Refresh button.

4.7.3Address Reservation

Selecting DHCP > Address Reservation will enable you to specify a reserved IP address for a PC on the LAN, so the PC will always obtain the same IP address each time when it accesses the AP. Reserved IP addresses should be assigned to servers that require permanent IP settings. The screen below is used for address reservation (shown in Figure 4-24).

Figure 4-24 Address Reservation

34