Figure 4-26 Wireless settings
¾Enable WMM - WMM function can guarantee the packets with high- priority messages being transmitted preferentially. It is strongly recommended enabled.
¾Enable AP Isolation - Isolate all connected wireless stations so that wireless stations can not access each other through WLAN. This option is available only for AP mode.
¾Disable short preamble - Disable short preamble and use long preamble only. It is recommended that you do not change these settings.
¾RTS threshold - RTS/CTS Threshold, the packet size that is used to determine if RTS/CTS should be sent.
¾Fragmentation Threshold - The maximum packet size used for fragmentation.
¾Beacon Interval - The interval time between two successive beacons.
¾Power - The transmit power of the access point. The checkbox determines the transmit power that whether it obeys regulatory power or not. Un-checking the Obey Regulatory Power option may cause interference to other devices and violate the applicable law.
¾Antenna Settings - The polarization of an antenna.
¾Signal LED Thresholds - The RSSI thresholds of the signal LEDs.
4.9Forwarding
There are four submenus under the Forwarding menu (shown in Figure
Virtual servers can be used for setting up public services on your LAN, such as DNS, Email and FTP. A virtual server is defined as a service port, and all requests from the Internet to this service port will be redirected to the computer specified by the server IP. Any PC that was used for a virtual server must have a static or reserved IP Address because its IP Address may change when using the DHCP function. Port Triggering is used for some applications that cannot work with a pure NAT router, like Internet games, video conferencing, Internet calling and so on, which
36
