Transition Networks SCSCF30XX-10X Set the Coax Grounding Jumpers, Install the Coax Cable

SCSCF30xx-10x

Installation -- Continued

CAUTION: Wear a grounding device and observe electrostatic discharge precautions when setting the jumper. Failure to observe this caution could result in damage to, and subsequent failure of, the Device.

Set the Coax Grounding Jumpers

Note: Modify the settings for J11 and J12 only if necessary.

Jumpers 11 and 12 (located on the circuit board near the coax ports) provide a grounding feature so that the SCSCF30xx-10x Device complies with the G.703 specification where:

•The output coax port is connected to chassis ground.

•A provision to connect the input coax port to chassis ground is provided.

The factory settings for these two jumpers are:

Jumper 12 (jumpered) = Output coax port is connected to chassis ground.

Jumper 11 (not-jumpered)= Input coax port is not connected to chassis ground.

J11 J12

No Jumper Jumper

The jumpers are located on the circuit board inside the Device housing. To set the jumpers:

1.Using a small screwdriver, remove the four (4) screws that secure the cover and carefully remove the cover from the Device.

2.Locate the jumper on the circuit board.

3.Using small needle-nosed pliers or similar device, move the jumper to the desired position. (Refer to the above drawing.)

4.Carefully replace the cover on the Device and replace the four (4) screws that secure the cover to the Device.

Installation -- Continued

Install the Coax Cable

1.Locate or build coax cables with female connectors installed at both ends.

2.Connect the coax cables to the Device as described:

•Connect the female TX cable connector to the male TX port.

•Connect the female RX cable connector to the male RX port.

3.Connect the coax cables to the other device (switch, workstation, etc.) as described:

•Connect the female TX cable connector to the male RX port.

•Connect the female RX cable connector to the male TX port.

RX			RX
TX			TX
	Connect the	Connect the
	coax cable to the	coax cable to the
	Media Converter	other device as
	as shown	shown

Install the Fiber Cable

1.Locate or build fiber cables with male, two-stranded TX to RX connectors installed at both ends.

2.Connect the fiber cables to the local SCSCF30xx-10x Device as described:

•Connect the male TX cable connector to the female TX port.

•Connect the male RX cable connector to the female RX port.

3.Connect the fiber cables to the remote SCSCF30xx-10x Device as described:

•Connect the male TX cable connector to the female RX port.

•Connect the male RX cable connector to the female TX port.

RX	RX
TX	TX
Connect fiber cable	Connect fiber cable
to media converter	to other device
as shown.	(media converter,
	hub, etc.) as shown

4 24-hour Technical Support: 1-800-260-1312 -- International: 00-1-952-941-7600 techsupport@transition.com -- Click the “Transition Now” link for a live Web chat. 5