Installing a Disk Enclosure in the Rack

Install the disk enclosures from the front of the rack, load enclosures from the top down, starting underneath the controller enclosure.

1.Align the slide rails mounted on the disk enclosure with the stationary flange mounts on the rack, as shown in Figure 12.

2253

Figure 12. Lifting Disk Enclosure and Aligning Enclosure slides

2.Slowly slide the enclosures slide rails into the flange mounts on the rack. If enclosure does not fit, adjust the Stationary Flange Mounts to fit the enclosure into the rack, as follows:

a.Remove enclosure that does not fit into place.

b.Loosen both Front and Rear Stationary Flange Mount mounting screws (refer to Figure 13) on both the right and left sides of the rack for that enclosure. Adjust the Stationary Flange Mounts, then secure mounting screws.

c.Repeat steps 1 and 2 until enclosure fits into rack.

18FibreSTORE RAID System: Rack Installation Guide

Page 18
Image 18
Ciprico 21021625 B manual Installing a Disk Enclosure in the Rack, Lifting Disk Enclosure and Aligning Enclosure slides