Ciprico 21021625 B manual Installing Mounting Brackets

Installing Mounting Brackets

A controller enclosure is shipped without the mounting brackets installed; you must install them before you install the controller enclosure in a rack. The Ciprico-provided install kit contains the parts you need to attach the mounting brackets to the controller enclosure and the enclosure to the rack.

Install the controller enclosure from the front of the rack.

1.Attach the brackets on both right and left sides of the controller enclosure with three counter-sunk Phillips head 1/4" #6-32 screws, as shown in Figure 15.

2.Align the slots on the mounting brackets of the controller enclosure with the cage nuts as shown in Figure 15.

Cage Nuts	Controller
	Enclosure

Support
			Controller
Angle		Controller
			2
	1

#10-32 Screws - 2 per side

#6-32Screws -	Controller Enclosure	2362
3 per side
	Mounting Brackets

Figure 15. Installing the Controller Enclosure in a Ciprico (Hoffman) Rack

3.Rest the controller enclosure on the support angles and slide the enclosure back and into place.

4.Secure the controller enclosure to the rack with four 1/2" #10-32 (2 per side) screws in the cage nuts as shown in Figure 15.

22FibreSTORE RAID System: Rack Installation Guide