Transition Networks SISTP10XX-141-LR(T) installation manual Wall mounting

Transition Networks SISTP10xx-141-LR(T) Industrial PoE Switch

Wall mounting

Wall mount	The Industrial PoE Switch includes wall mount brackets and screws in the contents of the
bracket	shipping package. The wall mount brackets can be attached to the top and bottom panels of
	the Industrial PoE Switch to enable mounting to a vertical surface such as the wall of an
	enclosure. Locate the brackets (2) and screws (8) and follow the steps below to install the
	brackets on the Industrial PoE Switch.
Wall mount	To install the wall mount brackets to the Industrial PoE Switch, see Figure 6 and do the
bracket install	following:
	Step	Action
	1.	Remove existing screws (3) and DIN-Rail bracket from rear of Industrial PoE
		Switch.
	2.	Locate wall mount brackets (2) and screws (8) from Industrial PoE Switch
		packaging.
	3.	Place brackets in correct orientation as shown and insert and tighten screws to
		secure bracket to the top and bottom of Industrial PoE Switch.
	4.	Mount assembled device to a wall per locally accepted practices for anchoring
		and securing. (Wall mount screws not included.)

Locate wall mount

brackets and screws

2

1

Remove screws and DIN rail bracket

3

Screw brackets onto top and bottom of Industrial Switch

Figure 6: Installing wall mount brackets to Industrial PoE Switch

10 24-Hour Technical Support: 1-800-260-1312 International: 00-1-952-941-7600