Transition Networks |
Grounding the Industrial PoE Switch
Wiring considerations
CAUTION
Be sure to disconnect the Industrial PoE Switch from the DC power source before installing and wiring the device.
The following wiring considerations are recommended:
•Signal lines must not be directly connected to outdoor wiring.
•Use separate paths or conduits to route wiring for power and device data cables. To avoid interference, wires with different signal characteristics route separately. If power wiring and device data cables must cross make sure that the wires are perpendicular at the intersection point.
•Use the type of signal transmitted through a wire to determine which wires should be kept separate. The rule of thumb is wiring that shares similar electrical characteristics can be bundled together.
•Keep input and output wiring separated.
| CAUTION |
| The Industrial PoE Switch is intended to be grounded to a |
| surface such as a metal plate. Install the grounding wire prior to connecting any other |
| device to the Industrial PoE Switch. |
|
|
Industrial PoE | Grounding the Industrial PoE Switch helps limit the effects of noise due to electromagnetic |
Switch | interference (EMI) via proper grounding. Always run the ground connection from the ground |
grounding | screw to a grounding surface before connecting the Industrial PoE Switch to a DC power |
| source. See Figure 7. |
Figure 7: Industrial PoE Switch Ground Screw (Top Panel)
| 11 |
