Transition Networks |
DIN rail mounting
DIN rail clip | The Industrial PoE Switch includes an aluminum DIN Rail Clip attached to the rear panel. |
| Verify the clip is attached and oriented as pictured in Figure 4 below. |
DIN Rail Clip (installed)
Metal spring
Screws (3)
| Figure 4: Mounted DIN Rail Clip |
|
|
DIN rail mounting | Consider the following before mounting the DIN rail to a surface and attaching the Industrial |
considerations | PoE Switch: |
| • The surface must support at least 450g (1.0 lbs) for the Industrial PoE Switch. |
| • Do not place heavy objects on the Industrial PoE Switch. |
| CAUTION |
| Mount the Industrial PoE Switch with proper spacing around it for ventilation (heat |
| dissipation). Failure to observe this caution could result in damage to the Industrial PoE |
| Switch. |
| CAUTION |
| Please exercise caution when using power tools. Do not install this unit in damp or wet |
| locations, or in close proximity to very hot surfaces. Failure to observe this caution could |
| result in damage to the Industrial PoE Switch and cables. |
|
|
| Continued on next page |
8 |
