Tripp Lite B096-016, 93-2879, B096-048 owner manual Trusted Networks

So your new User will be the existing total plus 1, so if the previous command gave you 0, then you start with user number 1. If you already have 1 user, your new user will be number 2, etc.

If you want a user named “user1” with a password of “secret” who will have access to serial port 5 from the network, you need to issue the these commands (assuming you have a previous user in place):

#/bin/config –-set=config.users.user2.username=user1

#/bin/config –-set=config.users.user2.password=secret

#/bin/config –-set=”config.users.user2.description=The Second User”

#/bin/config –-set=config.users.user2.port5=on

#/bin/config –-set=config.users.total=2

The following command will synchronize the live system with the new configuration.

# /bin/config –-run=users

Trusted Networks

You can further restrict remote access to serial ports based on the source IP address. To configure this via the command line, you need to do the following:

Determine the total number of existing trusted network rules. If you have no existing rules, you can assume this is 0.

# /bin/config –-get=config.portaccess.total

This command should display:

config.portaccess.total 1

Note that if you see:

config.portaccess.total

This means you have 0 rules configured.

Your new rule will be the existing total plus 1. So if the previous command gave you 0, then you start with rule number 1. If you already have 1 rule, your new rule will be number 2, etc.

If you want to restrict access to serial port 5 to computers from a single C class network 192.168.5.0, you need to issue the following commands (assuming you have a previous rule in place):

# /bin/config –-set=config.portaccess.rule2.address=192.168.5.0

_____________________________________________________________________

B096-016 B096-048 and B092-016 User Manual Page 161