Supported
Supported Protocol Configuration
To ensure remote access to serial port 5 is configured as follows:
Telnet Access LAN | Disabled |
SSH Access LAN | Enabled |
Raw TCP via LAN | Disabled |
You would need to issue the following commands from the command line to set system configuration:
#/bin/config
#/bin/config
#/bin/config
The following command will synchronize the live system with the new configuration.
# /bin/config
Note: “/bin/config” commands can be combined into one command for convenience.
Users
You can add a User to the system from the command line by performing the following instructions:
Determine the total number of existing Users. If you have no existing Users, you can assume this is 0.
# /bin/config
This command should display: config.users.total 1
Note that if you see: config.users.total
This means you have 0 Users configured.
_____________________________________________________________________
Page 160 |