Activate Nagios notification if it is to be used for this event. In an SDT Nagios centrally managed environment, you can check the Nagios alert option. On the trigger condition (for matched patterns, logins, power events and signal changes), an NSCA check "warning" result will be sent to the central Nagios server. This condition is displayed on the Nagios status screen and triggers a notification. This can cause the Nagios central server itself to send out an email or an SMS, page, etc.
Select from the list of all configured serial ports, hosts, power units, monitors and probes which devices this new alert is to be applied to. Select Applicable Port(s) (serial) and/or Applicable Host(s) and/or Applicable UPS(es) and/or Applicable RPC(s) and/or Applicable EMD(s) and/or Applicable Alarm Sensor(s) that are to be monitored for this alert trigger
7.2.2Select general alert type
Select the Alert Type (Connection, Signal, Pattern Match, UPS Status or Environment and Power) that is to be monitored. You can configure a selection of different Alert types and any number of specific triggers
Connection Alert - This alert will be triggered when a user connects or disconnects from the applicable Host or Serial Port, or when a Slave connects or disconnects from the applicable UPS
Serial Port Signal Alert - This alert will be triggered when the specified signal changes state and is applicable to serial ports only. You must specify the particular Signal Type (DSR, DCD or CTS) trigger condition that will send a new alert
98
