Tripp Lite B070-008-19 owner manual Connecting the Power Supply, Resetting the KVM Switch

Installation (continued)

Connecting a NetCommander USB Server Interface Unit (Model # B078-101-USB)

1.Connect the B078-101-USB VGA connector to the computers VGA port

2.Connect the B078-101-USB USB connector to the computers USB port

3.Connect one end of the Cat5 patch cable to the RJ45 port on the B078-101-USB*

4.Connect the other end of the Cat5 patch cable to the desired RJ45 port on the Console KVM.* The green LED will illuminate when the SIU is connected and receiving power.

5.Repeat these steps for each additional USB computer/server you are connecting to the Console KVM

* Cat5 cable should be no longer than 100 ft.

Up to 100 ft

SIU = Server Interface Unit

Figure 5 NetCommander USB Server Interface Unit

Connecting the Power Supply

1.Plug in the KVM using only the power cord supplied with the unit.

2.Switch ON the Console KVM.

Resetting the KVM Switch

To reset the KVM switch, turn the unit off and then back on using the power switch on the

back. The Server Interface Units are unaffected by this reset.

7