Tripp Lite SMX1500XLRT2U, SMX500RT1U, SMX3000XLRT2U, SMX1000RT2U, SMX750RT1U Procedure, Output

Battery Replacement

Under normal conditions, the original batteries in your UPS will last many years. See Safety section before replacing batteries. The batteries are designed for hot-swap replacement (i.e. leaving the UPS in ON mode), but qualified service personnel may wish to put the UPS in the OFF mode before proceeding.

1U UPS Models

TPRO UPS
1	6
2	5

3 4

Procedure

1Remove Front Panel

2Disconnect Batteries

3Remove/Dispose of Batteries

4Add Batteries

5Connect Batteries

Attach connectors: black- to-black and red-to-red.

6Replace Front Panel

2U UPS Models

SMARTPRO UPS
1	6

2 5

3 4

Specifications

Model	SMX500RT1U	SMX750RT1U	SMX1000RT2U	SMX1500XLRT2U	SMX3000XLRT2U
Series #	AGSMX500RT1U	AGSM751SRM1U	AGSM4724	AGSM152DRTI2U	AGSM4878
Input
Nominal Voltage/Frequency:	230VAC, 50/60Hz	230VAC, 50/60Hz	230VAC, 50/60Hz	230VAC, 50/60Hz	230VAC, 50/60Hz
Suggested Circuit:	10 amp	10 amp	10 amp	10 amp	20 amp
Output
Capacity (VA/Watts)	500/300	750/450	1000/700	1500/1000	3000/2250
On Line Nominal Voltage/Waveform:	230VAC/sine wave	230VAC/sine wave	230VAC/sine wave	230VAC/sine wave	230VAC/sine wave
On Battery Nominal Voltage/Waveform:	230VAC/PWM sine wave	230VAC/sine wave	230VAC/sine wave	230VAC/sine wave	230VAC/sine wave
Battery Recharge Time (to 90% charge)	2-4 hrs.	2-4 hrs.	2-4 hrs.	2-4 hrs.	2-4 hrs.
Typical Transfer Time	2-4 ms.	2-4 ms.	2-4 ms.	2-4 ms.	2-4 ms.
Approvals:	CE, GOST, SASO, IRAM	CE, GOST, SASO, IRAM	CE, GOST, SASO, IRAM	CE, GOST, SASO, IRAM	CE, GOST, SASO, IRAM

ALL MODELS: Voltage-Regulated Output Voltage Range (230V +/- 9%); On Battery Output Voltage Range (230V +/- 5%); AC Surge Suppression (exceeds IEEE 587 Cat. A & B standards); AC Noise Attenuation (>40 dB); AC Protection Modes (H to N).

The policy of Tripp Lite is one of continuous improvement. Specifications are subject to change without notice.

Note on Labeling

Two symbols are used on the label.

V~ : AC Voltage

V : DC Voltage

12