Tripp Lite XL INT specifications Storage & Service, Specifications, Wire Color-Code Chart

External Battery Connector

Use to connect additional Tripp Lite battery packs for additional runtime. Refer to the label next to the connector for the appro- priate Tripp Lite battery pack to connect. Refer to instructions available with the battery pack for complete connection informa- tion and safety warnings.

Storage & Service

Storage

Turn your UPS OFF: first engage the ON/Standby Switch and release it to place your UPS in the “Standby” mode, then move the System Enable Switch to the "DISABLE" (DOWN) position to prevent battery drain, then disconnect the UPS power cord from the wall outlet. If you plan on storing your UPS for an extended period of time, recharge the UPS batteries once every three months. Follow steps #1 and #3 in the Quick Installation section and allow the UPS to charge from 4 to 6 hours. If you leave your UPS batteries discharged for an extended period of time, they will suffer permanent loss of capacity.

Service

If returning your UPS for service, contact your local Tripp Lite dealer or distributor. They will refer you to a service center. Please carefully pack the UPS using the ORIGINAL PACKING MATERIAL that came with the unit. Enclose a letter describing the symptoms of the problem. If the UPS is within the 2 year warranty period, enclose a copy of your sales receipt.

Specifications

	Smart INT 2200	Smart INT 3000
Output Capacity (VA/Watts):	2200/1700	3000/2400
Battery Runtime (Half Load/
Full Load) Minutes:	27+/11+*	23+/7+*
Battery Recharge Time:	2-4 hrs.	2-4 hrs.
Approvals:	UL, CE	UL, CE

* Battery Runtime for this model can be increased with the addition of optional external battery packs.

Input Voltage (230V); Input Frequency (50/60 Hz, Auto-Selecting); On-Line Input Voltage Range (166-276 volts); Voltage-Regulated Output Voltage Range (230V +8%/-15%); On-Battery Output Voltage Range (230V ± 5%); Output Waveform Line Mode (filtered sinewave); Output Waveform Battery Mode (PWM sine wave); AC Surge Suppression (exceeds IEEE 587 Cat. A & B standards); AC Noise Attenuation (>40 dB); AC TVSS Protection Modes (H to N, H to G, N to G).

Wire Color-Code Chart

Wire Color	Wire 1	Wire 2	Wire 3
American	Black	White	Green	Black	Brown
European	Brown	Blue	Green/Yellow	White	Blue
Wire Reference	Wire 1	Wire 2	Wire 3	AMER	EURO
American	Line 1	Neutral	Ground
					Green/
European	Line 1	Line 2 or Neutral	Ground	Green
					Yellow

The policy of Tripp Lite is one of continuous improvement. Specifications are subject to change.

7