Troy-Bilt 203779GS manual Howto UseSpray Tips, LowPressure High Pressure, Notice

8#

8#

8#

2.Place spray gun through hole on accessory tray on right side of unit.

NOTE:You may also usethe spray gun holder wireform attached to the handleto store your spray gun and nozzle extension, as shown in Featuresand Controls section.

3.Insert multi-colored spray tips in spaces provided in accessory tray.

4.Hang high pressure hose on hook attachedto accessory tray on front of tray, as shown.

Howto UseSpray Tips

The quick-connect on the nozzleextension allows you to switch betweenthree different quick connect spray tips. Spray tips can be changed while pressure washer is running once spray gun trigger lock is engaged.The spray tips vary the spray pattern as shown below.

LowPressure High Pressure

_ L ri t

	Black	25° Green	0° Red
	Useto apply	1750 PSI	2500 PSI
	detergent	2.3 GPM	2.0 GPM
Fellow these instructionsto changespray tips:
1. Engagetrigger lock on spray gun.
		WARNING
	The high pressure stream of water that this
_	underlyingquipment tissues,producesleadingtocancutthroughserious skininjuryandandits
	possible amputation.

•NEVERexchangespraytipswithoutlockingthetriggerlockon the spraygun.

•DONOTtwistspraytips whilespraying.

2.Pull backcollar on quick-connect and pull current spray tip off. Store spray tips in holder provided on the accessory tray.

3.Select desired spray tip:

•For gentle rinse, select green 25° spray tip.

•To scour surface, select red 0° spray tip.

•To apply detergent, select black spray tip.

4.Pull back on collar, insert new spray tip and release collar. Tug on spray tip to make sure it is securely in place.

Usage Tips

•For most effective cleaning, keep spray tip from 8 to 24 inches away from cleaning surface.

•If you get spray tip too close, especially using a high pressure spray tip, you may damage surface being cleaned.

•DO NOTget closer than 6 inches when cleaning tires.

Cleaning and Applying Detergent

CAUTION

Chemicalscan causebodily injury, and/or property damage.

NEVERusecausticliquidwith pressurewasher.

UseONLYpressurewashersafedetergents/soapsFollowall.

manufacturersinstructions.

To apply detergent, fellow these steps:

1.Review use of spray tips.

2.Preparedetergent solution as required by job.

3.Place small filter end of detergent siphoning tube into detergent container.

NOTICE

Contact with the hot muffler can damagedetergent siphoning tube.

Wheninsertingthe filterinto adetergentsolutionbottle,route thetubeso asto keepit from inadvertentlycontactingthe hot muffler.

NOTE:Makesure the filter is fully submerged in detergent while applying detergent.

4. Make sure black spray tip is installed.

NOTE:Detergent cannot be applied with the high pressure spray tips (Greenor Red).

14 www.troyhilt.cem