Howto Start YourPressureWasher
To start your pressure washer for the first time, follow these instructions
aday.
1.Place pressure washer near an outside water source capable of supplying water at a flow rate greater than 3.3 gallons per minute and no less than 20 PSI at pressure washer end of garden hose. DO NOTsiphon supply water.
2.Checkthat high pressure hose is tightly connectedto spray gun and pump. SeeAssembly section.
3.Make sure unit is in a level position.
4.Connect garden hose to water inlet on pressure washer pump.
NOTICE
DO NOTrun the pump without the water supply connected and turned on. ________
I" Damageto equipmentresultingfromfailureto followthis h instructionwill voidwarranty.
5.Turn 0I/water, point spray gun in a safe direction and squeezetrigger to purge pump system of air and impurities.
6.Attach nozzleextension to spray gun. Tighten by hand.
7. Engagetrigger lock (A) on spray gun trigger.
8.When starting engine, position yourself as recommended and start engine according to instructions given in engine operator'smanual. Also see operating instructions tag locatedon the pressure washer.
WARNING
Startercord kickback (rapid retraction) can result in bodily injury. Kickbackwill pull hand and arm
_,_< toward engine faster than you can let go.
Broken bones, fractures, bruises, or sprains could result.
•NEVERpull startercordwithoutfirst relievingspraygun pressure.
. Whenstartingengine,pullcordslowlyuntil resistanceis feltand thenpullrapidlyto avoidkickback.
. Aftereachstartingattempt,whereenginefailsto run,always pointsprayguninsafedirectionandsqueezesprayguntrigger to releasehighpressure.Engagesprayguntriggerlock.
•Firmlygraspspraygunwith bothhandswhenusinghigh pressuresprayto avoidinjurywhenspraygunkicksback.
12 | www.troybilt.¢om |
