Add En{jineOil and Fuel
•Place pressure washer on a level surface•
NOTE:Verify provided oil bottle is the correct viscosity for current ambient temperature•
•Referto engine operator'smanual and follow oil and fuel recommendations and instructions•
NOTICE
Any attempt to crank OFstart the engine before it has been properly filled with the recommended oil will result in
_ment failure•
Referto enginemanualfor oilandfuel fill information•
Damageto equipmentresultingfromfailureto followthis instructionwill voidwarranty•
NOTE:Checkoil often during engine
Connect Hose and Water Supply to Pump
NOTICE
DO NOTFunthe pump without the water supply connected
and turned on. _ __m
I" Damageto equipmentresultingfromfailureto followthis h instructionwill voidwarranty•
NOTE:Removeand discard the shipping caps from the pump'shigh pressure outlet and water inlet before attaching hoses•
1.Uncoil high pressure hose and attach one end of hose to base of spray gun. Tighten by hand•
| WARNING |
| The high pressurestream of water that this |
_ | quipment produces can cut through skin and its |
| underlying tissues, leadingto serious injury and |
| 3ossible amputation• |
•NEVERconnecthighpressurehoseto nozzleextension•
,Keephighpressurehoseconnectedto pumpandspraygun whilesystemis pressurized•
,Alwaysbecertainspraygun,nozzlesandaccessoriesare
correctlyattached•
2.Attach other end of high pressure hose to high pressure outlet on pump• Tighten by hand•
3.Run water through your garden hose for 30 seconds to clean out any debris•
IMPORTANT:DO NOTsiphon standing water for the water supply• UseONLYcold water (less than I O0°F).
4.Before connecting garden hose to water inlet, inspect inlet screen (A). Cleanscreen if it contains debris or have it replaced if damaged•DO NOTFunpressure washer if inlet screen is damaged•
5.Connectthe garden hose (not to exceed50 feet in length) to the water inlet• Tighten by hand•
NOTICE
Damageto pump or water inlet connector will occur if a OneWay Valve (vacuum breaker or check valve) is connected to pump•
ThereM/USTbeat leastten feet(31Vl)of unrestrictedgarden hosebetweenthe pressurewasherinletandanydevice,suchas aOneWayValve•
Damageto equipmentcausedby attachinga OneWayValveto pumpwill voidwarranty•
6.Turn ON the water and squeezethe trigger on the spray gun to purge the pump system of air and impurities•
WARNING
Risk of eye injury.
• _ ISpray can splash back or propel objects• Alwayswearsafetygoggleswhenusingthis equipmentor in vicinityof whereequipmentis in use.
Beforestartingthe pressurewasher,besureyouarewearing adequatesafetygoggles•
NEVERsubstitutesafetyglassesfor safetygoggles•
Checklist Before Starting Engine
Review the unit'sassembly to ensure you have performed all of the following•
1.Be sure to readthe Operator Safetysection and How to Use Your Pressure Washer in Operationsection before using pressure washer•
2.Make sure handle is in place and secure•
3.Checkthat oil has been addedto proper level in the engine crankcase•
4.Add proper fuel to fuel tank•
5.Checkfor properly tightened hose connections•
6.Checkto makesure there are no kinks, cuts, or damage to high pressure hose•
7.Provide a proper water supply at an adequateflow•
CD
3
