user manual
NuQ series
Ceiling Mounting
•Remove the blanking screws from the rear panel of the loudspeaker (there are two M6 hex countersunk screws on the
•Mount the bracket to the ceiling using suitable fixings.
•Offer up the loudspeaker using suitable lifting equipment and attach the speaker plate to the rigging points on the rear of the loudspeaker.
•Angle as necessary and tighten all fixings.
Small Loudspeaker Arrays
NuQ series loudspeakers offer two choices of dispersion pattern, and this facility gives considerable flexibility of coverage when assembling small loudspeaker arrays. By rotating the Converging Elliptical Waveguides within the cabinet it is possible to obtain either wide horizontal coverage or narrow horizontal coverage. The table below shows the possible dispersion options for each model.
Model | ||||
|
|
|
|
|
100°H x 60°V | 100°H x 60°V | 80°H x 50°V | 80°H x 50°V | |
|
|
|
|
|
HF horn rotated | 60°H x 100°V | 60°H x 100°V | 50°H x 80°V | 50°H x 80°V |
|
|
|
|
|
Horizontal Rigging
Where ceiling height is limited or for other aesthetic reasons it may be desirable to mount cabinets horizontally. The
swivel bracket is used for this purpose, and can be fixed directly to a ceilings, or truss mounted using the
horizontally the high frequency horn should be rotated through 90°. For instructions on rotating
the horn please refer to the servicing section of
NuQ manual page 35
