2.04 – SAS Disable Jumper (JP1)
For external disable SAS controller
Installed: Disable
Not installed: Enable (Default)
(Default)
2.05 – OPMA card supporting select header (JP2)
| When using other OPMA card, remove jumper |
|
|
| When using TYAN OPMA card, install jumper |
(Default) | (default) |
| |
|
|
2.06 – Clear CMOS (JP3)
Normal (Default)
Clear
Use this jumper when you have forgotten your system/setup password or need to clear the system BIOS settings.
How to clear the CMOS data
-Power off system and disconnect the power supply from the AC source
-Use jumper cap to close pin_2 and 3 for several seconds to clear the CMOS
-Replace the jumper cap to close pin_1 and pin_2 Reconnect the power supply to the AC source and power on the system
2.07 – USB Front Panel Header (J2)
VCC | 1 | 2 | VCC |
DATA- | 3 | 4 | DATA- |
DATA+ | 5 | 6 | DATA+ |
GND | 7 | 8 | GND |
KEY | 9 | 10 | NA |
|
|
|
|
14
http://www.TYAN.com
