Tyan Computer N3600T, S2937 warranty Phoenix Bios Post Code, Code Beeps / Description

4.2 Phoenix BIOS Post Code

Code			Beeps / Description
02h		Verify Real Mode
03h		Disable Non-Maskable Interrupt
		(NMI)
04h	Get CPU type
06h	Initialize system hardware
08h	Initialize chipset with initial
		POST values
09h	Set IN POST flag
0Ah		Initialize CPU registers
0Bh		Enable CPU cache
0Ch		Initialize caches to initial POST
		values
0Eh	Initialize I/O component
0Fh		Initialize the local bus IDE
10h		Initialize Power Management
11h	Load alternate registers with
		initial POST values
12h	Restore CPU control word
		during warm boot
13h	Initialize PCI Bus Mastering
		devices
14h		Initialize keyboard controller
16h		1-2-2-3	. BIOS ROM checksum
17h		Initialize	cache before memory
		autosize
18h	8254 timer initialization
1Ah		8237 DMA controller
		initialization
1Ch		Reset Programmable Interrupt
		Controller
20h		1-3-1-1. Test DRAM refresh
22h		1-3-1-3. Test 8742 KBD
		Controller
24h	Set ES segment register to 4
		GB
26h		Enable A20 line
28h	Autosize DRAM
29h		Initialize POST Memory
		Manager
2Ah	Clear 512 KB base RAM
2Ch		1-3-4-1	. RAM failure on
		address
2Eh		1-3-4-3	. RAM failure on data
		bits of	low byte of memory bus
2Fh	Enable cache before system
		BIOS shadow
30h		1-4-1-1	. RAM failure on data
		bits of	high byte of memory bus

Code		Beeps / Description
32h	Test CPU bus-clock frequency
33h		Initialize Phoenix Dispatch
		Manager
36h	Warm start shut down
38h	Shadow system BIOS ROM
3Ah		Autosize cache
3Ch	Advanced configuration of
		chipset registers
3Dh		Load alternate registers with
		CMOS values
42h		Initialize interrupt vectors
45h		POST device initialization
46h		2-1-2-3	. Check ROM copyright
		notice
48h	Check video configuration
		against CMOS
49h		Initialize PCI bus and devices
4Ah		Initialize all video adapters in
		system
4Bh		QuietBoot start (optional)
4Ch	Shadow video BIOS ROM
4Eh	Display BIOS copyright notice
50h		Display CPU type and speed
51h		Initialize EISA board
52h	Test keyboard
54h		Set key click if enabled
58h		2-2-3-1	. Test for unexpected
		interrupts
59h	Initialize POST display service
5Ah		Display prompt "Press F2 to
		enter SETUP"
5Bh		Disable CPU cache
5Ch	Test RAM between 512 and
		640 KB
60h		Test extended memory
62h	Test extended memory address
		lines
64h	Jump to UserPatch1
66h		Configure advanced cache
		registers
67h		Initialize Multi Processor APIC
68h	Enable external and CPU
		caches
69h	Setup System Management
		Mode (SMM) area

71

http://www.tyan.com