Tyan Computer S8236 warranty Remote Access Configuration, Serial Port Number, Serial Port Mode

3.3.7 Remote Access Configuration

BIOS Setup Utility

Main Advanced PCI/PnP Boot Security Chipset Exit

Configure Remote Access type and parameters

Remote Access	[Disabled]
Serial Port Number	[COM1]
Base Address, IRQ	[3F8h, 4]
Serial Port Mode	[38400 8, n, 1]
Flow Control	[None]
Redirection After BIOS POST	[Always]
Terminal Type	[ANSI]
VT-UTF8 Combo Key Support	[Enabled]
Sredir Memory Display Delay	[No Delay]

Select remote access type.

←Select Screen ↑↓ Select Item Enter Go to Sub Screen F1 General Help

F10 Save and Exit ESC Exit

Remote Access

Enables remote access to system through serial port.

Disabled / Enabled

NOTE:

The following BIOS items are available only when Remove Access is set to [Enabled].

Serial Port Number

Select Serial Port for cosole redirection. Make sure the selected port is enabled. COM1 / COM2

Serial Port Mode

Select Serial Port settings.

Flow Control

Select Flow Control for console redirection.

None / Hardware / Software

Redirection After BIOS POST

Disabled: Turns off the redirection after POST Boot Loader.

Boot Loader: Redirection is active during POST and during Boot Loader.

Always: Redirection is always active. (Some Oss may not work if set to Always) Always / Disabled / Boot Loader

Terminal Type

Select the target terminal type. ANSI / VT100 / VT-UTF8

58

http://www.tyan.com