Reversing the Door
All units may be left- or
Note: The grille should not yet be installed. If it has been installed, remove it for door reversing. See Page 10.
To reverse the door:
1.Remove top hinge from cabinet (three screws). See Figure 4. Hold door to keep it from falling.
2.Lift the door off the bottom hinge.
5.Relocate plastic spacer/ bushing on bottom of door to opposite side, and place door on bottom hinge pin. See Figure 8. Clean out bushing hole in door bottom with a screwdriver if necessary.
6.Remove plastic hole plug from door handle and relocate on opposite side. See Figure 9.
Bushing
Figure 8
Figure 4 | Figure 5 |
3.Remove bottom hinge from cabinet (two screws). See Figure 5. Remove screws on opposite side of cabinet (Figure 6). Note that there may be a nut behind one or both screws on either side.
| Hinge |
|
Plastic |
| Plastic |
Plug Hole |
| Plug Hole |
| Screw |
|
Right Side |
| Left Side |
Door Swing |
| Door Swing |
Right Side | Invert | Invert |
Hinge | Screw | Hinge |
Figure 9 |
|
|
7.Remove pivot screw from top hinge, invert screw and reinstall pivot screw in top hinge. See Figure 9.
Figure 6 |
Figure 7 |
8.Remove three plastic screw plugs from hinge holes, top of cabinet, opposite side. Be careful not to scratch cabinet. See Figure 10.
9.Place door on lower hinge pin. Invert and install upper hinge on door.
Figure 10 |
4.Install hinge on opposite side, bottom of cabinet. See Figure 7. Replace nut on back side where installed. Align hinge outer edge with cabinet before tightening screws.
02/2005 | 5 |
