U-Line CO29, CO75 manual Ice Maker Maintenance

1

2

ULIN_0154_A

Figure 13

6.Place the two hook-hinges (Figure 13, 1) located on the rear bottom side of the grille onto the front lip of the unit base. Tilt the grille up into position and align the grille mounting hole with the grille screw hole on the cabinet.

7.Insert the screw (Figure 11, 2). Do not overtighten.

8.Reinstall the control knob (Figure 11, 1).

9.Reconnect power to the unit.

Ice Maker Maintenance

Inlet Screen

Interval - Every Twelve Months

The solenoid valve inlet screen must be cleaned at least once each year as follows:

1.Shut off the water at the main supply valve.

2.Pull the unit out to access the back panel.

3.Disconnect electrical power to the unit.

2

1

ULIN_0054_A

Figure 14

4.Disconnect the hose connector (Figure 14, 1) from the water solenoid valve (Figure 14, 2).

5.DO NOT remove the inlet screen from the water solenoid valve. Use a tooth brush to gently clean any sediment from the inlet screen.

6.Re-connect the water supply hose connector (Figure 14, 1) to the water solenoid valve (Figure 14, 2). Tighten the connector securely.

7.Open the water main supply valve and check for leakage at the water hose connection. Ensure that the water supply line is not kinked.

8.Reconnect power to the unit before re-installing.

Ice Cube Thickness Adjustment

Interval - As Required

On ice maker equipped models, the cube size may be adjusted by changing the amount of water injected into the ice maker assembly as follows:

automatic

ICE MAKER

ULIN_0055_A

Figure 15

1. Remove the ice maker assembly cover (Figure 15).

ULIN_0056_A

Figure 16

2.Locate the adjusting screw on the ice maker assembly control box. The adjusting screw is just below the minus (-) and plus (+) signs on the control box (Figure 16).

NOTE: Make adjustments in small increments. Too large of an adjustment could cause the unit to malfunction.

CAUTION

Too large of an adjustment to the screw can cause the water to overflow the ice maker and can cause property damage.

3.Turn the adjusting screw toward the minus (-) sign (clockwise) for smaller cubes or toward the plus (+) sign (counterclockwise) for larger cubes.

4.Install the ice maker assembly cover.

12 CO29, CO75