U-Line CO29, CO75 manual Door Reversal

Door Reversal

CO29:

Depending upon the location of the unit, it may be desirable to change the side on which the door is mounted. NOTE: On built-in installations, changing the door mounting to the left side may interfere with ice bucket removal.

To reverse the door mounting, perform the following:

1

ULIN_0014_A

Figure 20

1.Remove the control knob (Figure 20, 1) by pulling it away from the cabinet.

2.Remove two grille screws, and remove the grille.

ULIN_0210_A

Figure 21

1.Remove top hinge from cabinet (three screws) (Figure 21). Hold door to keep it from falling.

2.Lift the door off the bottom hinge.

ULIN_0215_A

Figure 22

3.Remove bottom hinge from cabinet (two screws) (Figure 22).

ULINE_0216_A

Figure 23

4.Remove screws on opposite side of cabinet (Figure 23). Note that there may be a nut behind one or both screws on either side.

ULINE_0217_A

Figure 24

5.Install hinge on opposite side, bottom of cabinet (Figure 24). Replace nut on back side where installed. Align hinge outer edge with cabinet before tightening screws.

14 CO29, CO75