MARINE SERIES
6.Install hinge on opposite side, bottom of cabinet (Figure 18). Align hinge outer edge with cabinet before tightening screws.
Figure 18
Plastic
Spacer/Bushing
ULIN_0109_A
Figure 19
7.Relocate plastic spacer/bushing (Figure 19) on top and bottom of door to opposite side. Clean out bushing hole in door bottom with a screwdriver if necessary.
8.Using a Phillips screwdriver, remove the two screws holding the custom stainless handle from the original location, and remove the handle. Remove the two screws on the opposite side of the door (Figure 20). Do not place handle on door until you have completed steps 9 & 10.
ULIN_1049_A |
Figure 20
|
| Hinge |
|
Plastic |
|
| Plastic |
Plug Hole |
|
| Plug Hole |
|
| Screw |
|
Right Side |
|
| Left Side |
Door Swing |
| Invert | Door Swing |
| Right | Invert | |
| Screw | ||
|
| Hinge | |
Side Hinge | |||
|
|
| ULIN_0142_A |
Figure 21
9.Remove plastic hole plug (Figure 22) from door handle and relocate on opposite side. Lift the handle slightly and press on the locking tab, then gently pry the hole plug out of the hole being careful not scratch the top cap.
Press in locking tab, then lightly pry up to remove hole plug and move to opposite 
side
ULIN_1050_A
Figure 22
10.Relocate plastic spacer/bushing on top of door that was underneath the hinge to the opposite hole in top cap
11.Attach handle removed in step 7 to opposite side of door frame. Be sure to tighten all four screws removed in step 7.
12.Remove pivot screw from top hinge, invert screw and reinstall pivot screw in top hinge (Figure 21).
12 | SS1095 |
