U-Line SS1095 Ice Maker Maintenance, Inlet Screen Interval - Every Twelve Months, Marine Series

MARINE SERIES

1.Disconnect electrical power to the unit.

2.With a standard blade screwdriver or 1/4" nut driver, remove the grille screw (Figure 8).

3.Remove the grille.

WARNING

DO NOT touch the condenser fins. The condenser fins are SHARP and can be easily damaged.

IMPORTANT

DO NOT use any type of cleaner on the condenser unit.

4.Clean the condenser coil using a soft brush with a “combing” action or vacuum cleaner. Do not touch the condenser coil.

5.Depending on your model, follow the instructions for installing the grille (Figure 9).

SS1095NF & SS1095FC models: Place the bottom lip of the grille on the inside of the base pan and swing grille up into position.

SS1095FD model: Align the tabs on the bottom of the grille with the slots in the flange and swing grille up into position.

Align the grille and cabinet screw holes (Figure 9).

Model SS1095FD

Models

SS1095NF

& SS1095FC

Align tabs

with slots

Insert this lip behind base plate lip

ULIN_1053_A

Figure 9

6.Insert the grille screw (Figure 8) and tighten. Do not over-tighten.

7.Reconnect power to the unit.

Ice Maker Maintenance

Inlet Screen

Interval - Every Twelve Months

The solenoid valve inlet screen must be cleaned at least once each year as follows:

WARNING

Disconnect electrical power to the unit before cleaning the solenoid valve.

1.Disconnect electrical power to the unit.

2.Shut off the water at the main supply valve.

3.With a standard blade screwdriver or 1/4" nut driver, remove the grille screw (Figure 8).

4.Remove the grille.

WARNING

DO NOT touch the condenser fins. The condenser fins are SHARP and can be easily damaged.

Water

Solenoid

Valve

Hose Connector

ULIN_0064_A

Figure 10

5.Disconnect the hose connector from the water solenoid valve (Figure 10).

6.DO NOT remove the inlet screen from the water solenoid valve. Use a toothbrush to gently clean any sediment from the inlet screen.

7.Re-connect the water supply hose connector to the water solenoid valve (Figure 10). Tighten the connector securely.

8.Open the water main supply valve and check for leaks at the water hose connection. Ensure that the water supply line is not kinked.

9.Depending on your model, follow the instructions for installing the grille (Figure 9).

SS1095NF & SS1095FC models: Place the bottom lip of the grille on the inside of the base pan and swing grille up into position.

SS1095 9