Ultratec INTELE-MODEM manual Calling with INTELE-MENU Commands, General procedure

CALLING WITH INTELE–MENU COMMANDS

General procedure __________________________________________

Set up your hardware, turn on the computer and modem, and load your communications software. Enter terminal mode. The communications program instructions will show you how to get into terminal mode (sometimes called “talk” or “on-line” mode).

1.Press the Escape Key and then the Spacebar to enter command mode. The Intele–Modem will display the following prompt on your computer screen:

Command (Press ? for help):

2.Type the letter or number for the command you want (or type ? to see the Help Menu). Commands are described starting on page 9.

3.Press the Enter Key to return to on-line mode and carry on your conversation.

If you don’t see the Command Line when you press the Escape Key and the Spacebar, try typing ATZ first. See the Problems and Solutions section on page 21 for more information.

Step-by-step instructions_____________________________________

Modem settings

When you follow these instructions, you will be using the following modem settings:

•Automatic communication mode. The modem will use either ASCII or Baudot code, depending on what it receives from the other computer or TTY.

•Half-duplex

•Pulse dialing

Instructions

1.Turn on your computer.

2.Start up your communications software.

3.Turn your Intele–Modem on. The POWER, BDT, and LO lights on the front panel of your modem will go on.

INTELE-MODEM

POWER

BDT ASC	HI	LO	CD	RXD	TXD	OH	SIG
CODE	SPEED		COMMUNICATION			PHONE

Turning on the Intele–Modem lights the Power, Baudot and Low Speed indicators.

4.Follow your software instructions to get into terminal mode.

5.Press the Escape Key and the Spacebar.

6.Type D and the telephone number you want to dial. If you make a mistake, use the Backspace Key to make corrections.

CALLING WITH INTELE-MENU COMMANDS • 5