Ultratec INTELE-MODEM manual What each command does, Telephone Functions

What each command does ___________________________________

Many of the commands have several settings. For example the Communication Code has three possibilities. It can be set to Automatic code detect, Baudot code, or ASCII code. When you turn the modem on, the Communication Code is set to Automatic code detect. Each time you type the command, it changes to the next setting. It will change to Baudot code the first time. The next time to ASCII code. The next time after that it will change back to Automatic code detect, and so on.

If the command has a default setting, it’s shown in parentheses after the name of the command. Commands are listed below in the order they appear on the Intele–Menu help menu.

Telephone Functions _________________________________________

D–Dial telephone

Use this command to place a call. When you enter D at the command prompt, you’ll see the following prompt:

Enter # to dial:

Type in the number, followed by the Enter Key. Include the area code if needed. The Intele–Modem will dial using either tone or pulse dialing, depending on how the T command is set. You can include parentheses and a dash in the number, although they’re not necessary. Type a comma within the phone number to get a two-second pause in dialing. Use as many commas as you need–each one equals two seconds. Examples of correct entries are:

1 (608) 255-1212

1-608-255-1212

16082551212

9,16082551212

9,,16082551212

A–Answer telephone

Use this command to answer a call. When you type A at the Command Line, the modem answers the phone and waits. You’ll see the following message:

Answering…

If the caller is using ASCII, you’ll see the response CONNECT. If the caller is using Baudot, you won’t see any response until you begin your conversation. Then you’ll see

CONNECT TTY.

H–Hang-up telephone

Typing H at the Command Line will hang up the phone. The modem will respond with Hanging up phone line and the Command Line will return.

T–Tone or pulse dialing (The default is Pulse)

Typing T changes the way the modem dials a number. The default setting is pulse dialing. Typing T at the Command Line changes the setting to tone dialing. Each time you use the command, it switches back and forth between pulse and tone dialing.

10 • THE INTELE-MENU COMMAND SET