Liquid Damage
CAUTION: If the base is covered in liquid, disconnect the adapter and phone cord from the wall before touching it.
If the liquid is only on the exterior housing of the base or handset, wipe it off and use as normal. If you can hear liquid inside the housing:
1.Disconnect all cables and cords and remove all compartment covers.
2.If liquid is leaking from any vent or hole, turn the phone so that vent faces down. If not, place the largest vent face down.
3.Let dry for at least 3 days. Check for liquid inside the phone before replacing compartment covers and reconnecting cords.
Resetting Stations
If you have problems with the base, unplug the base to reset it. Plug it back in after at least a minute.
If you have trouble with a cordless handset or if you want to replace one, reset it:
1.Press and hold Flash/exit and Pound (#) at the same time until System Reset displays (about 5 seconds).
2.If you still have the base the handset is registered to, select Deregister HS, then select the handset you want to reset. If you don't have that base anymore, select Base Unavailable.
3.To confirm, select Yes. The handset displays Handset not registered.
Registering a Handset
If you see a “not registered” message on a handset, you must register it to a base before using it.
1.On the base, open the menu and select Register Handset.
2.On the handset, press and hold Pound (#) until the handset display says Handset Registering (about 2 seconds).
3.Wait until the handset display says Registration Complete (about 30 seconds),
then pick up the handset and press Talk/end.
##If you don’t hear a dial tone or the display says Registration Failed, charge the battery completely, then try again.
