Uniden DCT7488 owner manual Setting a Security Code, Setting the Ring Time

played. Each time you press the CHANGE soft key, the phone switches the outgoing message between the prerecorded and the personal outgoing message.

To delete the personal greeting, press the DELETE soft key.

Setting a Security Code

You need to select a two-digit security code in order to play your messages from a remote location. When you try to access your messages from another phone, you must enter your security code.

note

Through this chapter, we use Handset LCD image to describe steps.

1)Press menu/clear (or the MENU soft key on the base). Select the Answ. Setup menu, and then the Security Code submenu.

2)Enter a two-digit security code (01-99) using the number keypad (0-9).

5GEWTKV[%QFG



AA

T H E I N T E G A N S W E R I N G

3)Press select/ /audio tone (or the OK soft key on the base). You will hear a confirmation tone.

Setting the Ring Time

Ring Time allows you to set the number of rings the caller hears before your answering system plays the outgoing message. You can set the ring time to answer after two, four, or six rings. If you enable the Toll Saver (TS), the answering system picks up after two rings if you have new messages, and after four rings if there are none.

R A T E D D E V I C E

1)Press menu/clear (or the MENU soft key). Select the Answ. Setup menu, and then the Ring Time submenu.

4KPI6KOG 6QNN5CXGT 6KOGU

w w w . u n i d e n . c o m T H E I N T E G R A T E D A N S W E R I N G D E V I C E [ 5 8 ]