5.Press and hold 
/BAND to start Limit search. The VFO knob allows you to toggle through the
bands. Then press 
/BAND again to start band search.
6.Press 
to stop Band serch, Limit search and WX scan. Also, press it to move to next higher channel or
frequency. Press and hold 
to change the search direction to upper side.
7.In Limit search, input the frequency and press 
to program the lower/higher frequency. Press 
to stop Band search, Limit search, and WX scan.
Also, press it to move to next lower channel or
frequency. Press and hold 
to change the search direction to lower side.
8.Press 
/ALERT to change the display mode when you program frequency or Alpha characters. Press and
hold 
/ALERT to set the Alert Beep function in Manual mode.
9.Use 
/CLR to enter the decimal point when programming a frequency into a channel. If you
make an entry error, press 
/CLR before the
key to erase the entry, and start over. Also, use
/CLR to clear the error message display.
10.Press 
to store a displayed frequency and CTCSS/CDCSS Data and Alpha characters into any displayed channel.
11.Press 
to “Lock Out” or prevent scanning of the displayed channel, including Priority Channels. (L/O
appears on the display.) To unlock a channel, press
again. 
can be used for Scan or SEARCH Modes.
12.There are 10 Preprogrammed NOAA and Canada
weather channels. Press 
/ATT to find the active NOAA and Canada weather channel in your area. WX appears on the display in Weather Mode. If you
want to set or reset the Attenuator function, press and
hold 
/ATT.
13
