Uniden SSE17+1 manual Installing the Rechargeable Battery for Cordless Handset

Warning: To avoid the risk of personal injury or property damage from fire or electrical shock, only use the Uniden battery model and Uniden adapter model specifically designated for this product.

Caution:

•Use only the specified Uniden battery pack (BT-905S).

•Do not remove the batteries from the handset to charge it.

•Never throw the battery into a fire, disassemble, or heat it.

•Do not remove or damage the battery casing.

Installing the Rechargeable Battery for Cordless Handset

1) Press down on the cordless handset battery case

cover (use the finger indention for a better grip) and slide the cover downward to remove.

2) Plug the battery pack connector (red & black wires) into the jack inside the battery compartment. (The connector notches fit into the grooves of the jack only

one way.) Match the wire colors to the polarity label in the battery compartment, connect the battery and listen for a click to insure connection.

3) Make sure you have a good connection by slightly pulling on the battery wires. If the connection is secure, the battery jack will remain in place.

4) Place the battery case cover back on the handset and slide it upwards until it clicks into place.

Note: Use only the Uniden BT-905S rechargeable battery pack supplied with your cordless telephone.

[54]

SSE17+1 OM.indb 54 15/7/08 12:08:47 PM