Note that the batteries are intended to provide backup power for the clock and for scanning for a short time. When the backup batteries becomes too
low,
appears. Promptly replace the batteries.
When you either install batteries or connect the AC Adapter to a standard Australia/New Zealand wall outlet, the scanner powers on and goes to STANDBY mode. The display shows the initial clock time of 12:00 AM. The scanner remains in STANDBY mode.
Connecting an
Antenna
The scanner uses an external loop antenna to receive AM broadcast
stations and an external telescopic antenna to receive all other signals.
Connect the supplied rod
antenna by pushing the antenna’s connector onto
the antenna jack on the back of the scanner and twisting it to the desired angle. Connect the two wires from the loop antenna to the AM RADIO ANT terminals on the back of the scanner.
* Carefully remove the tube inserted before using the AM Antenna Jack. When the Jack is not in use, keep the tube mounted.
You can also use an external antenna (not supplied) to help to bring in weaker signals. Use RG58,
Setting Up The Scanner
14
UBC40CRS OM.indd 4 | 7/5/08 4:8: PM |
