Channel Seeking Operation

Unlike normal scanning, CHANNEL SEEK is used more often when checking for active channels.

If a signal is detected, while seeking, the UH-100 will tune to that signal for 4 seconds only and then resumes Seeking Operation.

Changing from SCAN to SEEK Mode operation.

1.Firstly, activate SCAN mode.

2.Press and hold SCN until a "beep" is heard. The SCN icon starts to flash.

3.If an active channel is detected the UH-100 will stop on that channel for 4 seconds. (eg. CH17)

4.After 4 seconds, the UH-100 will start seeking again for active channels.

MEM SCN-,,---

I{71300MHz_, LI

MEM'y £ -r'~I ,-,

Pi\CI Cl

"'EM. ,-,s ...II)~ I I

I{ 76Bt?5MHz '

MEM'y~ "=1 ,-,

;sr:.CI Cl

5.If you find the channel interesting, simply press either the PTT switch or the SCN key to stop the operation before the 4 second timer elapses.

When SCN is pressed again SEEK is still the mode of operation.

To change back to SCAN, while SEEKING. press and hold SCN until a beep is heard. The SCN icon stops flashing.

m MEM

, ,-,

RF...11

I I-'

I{ 76.850MHz

 

-

MEM ,-, ,-,

SCNCl Cl

Note: SEEK checks the same channel stored in SCAN memory. Thus, you can Seek

either in OS or GS Mode.

17

Page 18
Image 18
Uniden UH-100 owner manual EM. ,-,s ...II~ I, Channel Seeking Operation