Terminal Equipment Radio Equipment | Uniden WXI377 manual

I.C. Notice

TERMINAL EQUIPMENT

NOTICE: This equipment meets the applicable Industry Canada Terminal Equipment Technical Specifications. This is confirmed by the registration number. The abbreviation, IC, before the registration number signifies that registration was performed based on a Declaration of Conformity indicating that Industry Canada technical specifications were met. It does not imply that Industry Canada approved the equipment.

NOTICE: The Ringer Equivalence Number (REN) for this terminal equipment is marked on the equipment itself. The REN assigned to each terminal equipment provides an indication of the maximum number of terminals allowed to be connected to a telephone interface. The termination on an interface may consist of any combination of devices subject only to the requirement that the sum of the Ringer Equivalence Numbers of all the devices does not exceed five.

RADIO EQUIPMENT

The term “IC:” before the radio certification number only signifies that Industry Canada technical specifications were met.

Operation is subject to the following two conditions: (1) this device may not cause interference, and

(2)this device must accept any interference, including interference that may cause undesired operation of the device. “Privacy of communications may not be ensured when using this telephone”.

www.uniden.com

A D D I T I O N A L I N F O R M AT I O N [ 45 ]

A D D I T I O N A L I N F O R M AT I O N

Image 45

Uniden WXI377 manual Terminal Equipment Radio Equipment

Contents

Page Page Base unit HandsetTelephone cord Contents Welcome Features Controls and Functions N T R O L S a N D F U N C T I O N S Choose the best location Setting up the PhoneDo the following steps Avoid microwave ovens Getting Started Activate the handset before charging the battery Replace the rechargeable handset battery pack Low battery alert Battery use time per chargeTalk Mode Standby Mode AC adapter Connect the base unit Standard wall plate mounting Mounting the Base Unit on a Wall Direct wall mounting Caller ID options Setting Menu Options Entering Your Area Code Choosing the dialing mode Setting the language Handset On Base Handset Off Base Making and Receiving Calls Handset ringer tone and volume Adjusting the Handset Ringer and Earpiece VolumeEarpiece volume Redial Traveling Out-of-Range Tone Dialing Switch-over Flash and Call Waiting Selecting a Different Channel Memory Dialing Storing Phone Numbers and Names E M O R Y D I a L I N G If you make a mistake while entering a name Steps for Entering Names and Special Characters Memory dialing from Standby Mode Memory dialing from Talk ModeMaking Calls with Memory Dialing Editing a Stored Name and/or Phone Number Chain Dialing Cursor flashes indicating that the display is ready for Press select or delete/ch Erasing a Stored Name and Phone Number RocketDial Storing and Editing the RocketDialMaking Calls with the RocketDial C K E T D I a L Deleting the RocketDial When the Telephone Rings You must subscribe to Caller ID service to use this featureCaller ID Press cid/menu Viewing the Caller ID Message List When the pointer is at No When the pointer is at YesDeleting Information from the Caller ID List Deleting a Caller ID message Using the Caller ID List Long Distance calls and Area Code Setting/CancellationCalling a party from the Caller ID list Storing Caller ID messages in Memory dialing Changing the Digital Security Code Installing the BeltclipTo attach the beltclip To remove the beltclip Battery replacement and handling MaintenancePower Failure When the handset or base unit becomes slightly dirty Symptom Suggestion Charge/in use LED wont Troubleshooting Symptom Suggestion Case Action Liquid Damage Battery Information General InformationAC Adapter Information Precautions Important Safety InstructionsImportant Electrical Considerations One Year Limited Warranty Installation Considerations Terminal Equipment Radio Equipment G, H At Uniden, we´ll take care of you