Activate the handset before charging the battery | Uniden WXI377

B. Activate the handset before charging the battery

The handset is powered by a rechargeable battery pack already installed in the handset’s battery compartment. Before charging the battery for the fist time, push the pin for activation, located on the bottom of the handset (see label with instructions). Once activated, remove the label and then place the handset in the base unit to charge.

Make sure to charge for 15-20 hours without interruption (do not plug the telephone cord into the unit and wall jack during charge time). The base unit’s LED light labeled (charge/in use) illuminates once the handset is placed in the base. The LED light will illuminate regardless if the battery pack is connected or not.

If the base charge/in use LED light does not illuminate:

•Check to see if the AC adapter is plugged into the base unit and the electrical wall outlet properly. (Use only the supplied AC adapter. Do not use any other AC adapter.)

•Check to see if the handset is sitting correctly in the base.

www.uniden.com

• Use only the Uniden (BT-909) rechargeable battery pack supplied with your cordless telephone.

• Replacement batteries and/or rubber seals are also available through the Uniden Parts Department at (800) 554-3988, Monday thru Friday from 8:00 a.m. to 5:00 p.m. or online at www.uniden.com

G E T T I N G S TA R T E D [ 9 ]

GETTING STARTED

Image 9

Uniden WXI377 manual Activate the handset before charging the battery, Getting Started

Contents

Page Page Base unit HandsetTelephone cord Contents Welcome Features Controls and Functions N T R O L S a N D F U N C T I O N S Choose the best location Setting up the PhoneDo the following steps Avoid microwave ovens Getting Started Activate the handset before charging the battery Replace the rechargeable handset battery pack Low battery alert Battery use time per chargeTalk Mode Standby Mode AC adapter Connect the base unit Standard wall plate mounting Mounting the Base Unit on a Wall Direct wall mounting Caller ID options Setting Menu Options Entering Your Area Code Choosing the dialing mode Setting the language Handset On Base Handset Off Base Making and Receiving Calls Handset ringer tone and volume Adjusting the Handset Ringer and Earpiece VolumeEarpiece volume Redial Traveling Out-of-Range Tone Dialing Switch-over Flash and Call Waiting Selecting a Different Channel Memory Dialing Storing Phone Numbers and Names E M O R Y D I a L I N G If you make a mistake while entering a name Steps for Entering Names and Special Characters Memory dialing from Standby Mode Memory dialing from Talk ModeMaking Calls with Memory Dialing Editing a Stored Name and/or Phone Number Chain Dialing Cursor flashes indicating that the display is ready for Press select or delete/ch Erasing a Stored Name and Phone Number RocketDial Storing and Editing the RocketDialMaking Calls with the RocketDial C K E T D I a L Deleting the RocketDial When the Telephone Rings You must subscribe to Caller ID service to use this featureCaller ID Press cid/menu Viewing the Caller ID Message List When the pointer is at No When the pointer is at YesDeleting Information from the Caller ID List Deleting a Caller ID message Using the Caller ID List Long Distance calls and Area Code Setting/CancellationCalling a party from the Caller ID list Storing Caller ID messages in Memory dialing Changing the Digital Security Code Installing the BeltclipTo attach the beltclip To remove the beltclip Battery replacement and handling MaintenancePower Failure When the handset or base unit becomes slightly dirty Symptom Suggestion Charge/in use LED wont Troubleshooting Symptom Suggestion Case Action Liquid Damage Battery Information General InformationAC Adapter Information Precautions Important Safety InstructionsImportant Electrical Considerations One Year Limited Warranty Installation Considerations Terminal Equipment Radio Equipment G, H At Uniden, we´ll take care of you